Spyridon Posted September 11, 2014 Share Posted September 11, 2014 (edited) I am working on my catalog filter options and noticed a few problems... 1) If I set navigation layered block modules filter template to a Drop-down list, if you click the list it opens briefly and then closes automatically in under a second. The only way to get it to work properly is to HOLD down left click and then mouse over the item you want then release. I can not expect my customers to figure this out, so would like to know how to make it so it only updates once clicking a 2nd time, like how drop down boxes typically work on websites. This problem is happening on both website on PC and mobile for me. 2) Since I noticed this problem I figured I would try a Radio button. But I noticed these do not work either. If you have 2 different options and select each, it adds both to the filter list. Radio buttons are only supposed to have "1" selected at any given time. But the radio button is functioning as a "checkbox". If anyone has any advice on how I can fix these it would be appreciated. Thanks Edited September 11, 2014 by Spyridon (see edit history) Link to comment Share on other sites More sharing options...
tracybfdx Posted October 20, 2014 Share Posted October 20, 2014 1. Noise suppression 2. Better frequency use ratio (6.25KHz) 3. Longer use time of the battery 4. Multi digital codes using for the transceiver 5. Support private call,group call and all call 6. 4 side keys can be programmed 7. High/Low voltage alarm 8. Dual-pin for out microphone and earphone 9. Built-in USB interface 10. 160 channels,50 zones 11. SMS 12. Manual dialing 13. Roger beep and emergency alarm [email protected] Link to comment Share on other sites More sharing options...
Recommended Posts